Filters
Collection
272 Results
-
HMAS Brisbane : Engine Room : Astern Control Wheel
Technology
Maker: Unknown
The Astern Control wheel consists of a cast alloy five spoke wheel. It is attached to a threaded shaft. The shaft runs through a cylindrical cast section on which are mounted a brass indicator plate a...REL32981.038
-
HMAS Brisbane : Engine Room : Bell assembly (section of) PORT
Technology
Maker: Unknown
This unit is circular in shape, made of metal and painted grey. On the front of the unit is engraved H-McC and 0000-S6504-74542. A grey metal bracket is also attached to the front of the unit. There a...REL32981.030
-
HMAS Brisbane : Engine Room : Boiler Maintenance Log Board
Technology
Maker: Unknown
The boiler maintenance log board consists of a rectangular piece of ply-wood with an acrylic cover. Under the acrylic cover is a piece of laminated paper chart with spaces for filling in daily mainten...REL32981.033
-
HMAS Brisbane : Engine Room : Electrical Box
Technology
Maker: Palmer Unknown
The electrical box consists of a rectangular brass case with rounded corners. At the back are two welded brass U channels drilled with three bolt holes. At the top and bottom of the case are two cable...REL32981.035
-
HMAS Brisbane : Engine Room : Gauge Board
Technology
Maker: Unknown
The engine room gauge board is a large alloy panel, rectangular in shape, with various gauges and pieces of equipment attached. Originally it had two rows of gauges although many have been removed - i...REL32981.003
-
HMAS Brisbane : Engine Room : Gauge Board
Technology
Maker: Unknown
The engine room gauge board is a large alloy panel, rectangular in shape, with various gauges and pieces of equipment attached. Many of the gauges have been removed - the upper half of the board has b...REL32981.002
-
HMAS Brisbane : Engine Room : Gauge Board labels
Technology
Maker: Unknown
Selection of gauge plates/labels from engine room gauge board (2 of 2). The plates are black plastic with white writing, rectangular in shape. They say -H.P Element 1st Stage Temp, Gland Steam, T/D Co...REL32981.010
-
HMAS Brisbane : Engine Room : Gauge Board Plate.
Technology
Maker: Unknown
Rectangular sheet of alloy with a thin layer of stainless steel bonded to the top surface. The markings are engraved on the top layer. They read: `H.M.A.S BRISBANE ' MAIN ENGINE CONDITIONS ' and then ...REL32981.009
-
HMAS Brisbane : Engine Room : Gauge Board Valve body
Technology
Maker: Unknown
The gauge board valve body is a grey metal unit, circular in shape, with a large moveable metal pole attached to the top. On the front of the valve is a brass indicator panel. At the top of the panel ...REL32981.040
-
HMAS Brisbane : Engine Room : Gauge Board Valve body
Technology
Maker: Unknown
The valve body is a cylindrical L shaped section of metal pipe, painted white. Both ends of the pipe are sealed ' having been bolted closed. A large screw protrudes from the base of the unit.REL32981.042
-
HMAS Brisbane : Engine Room : Gauge board valve body
Technology
Maker: Unknown
The gauge board valve body is a circular, grey metal unit. On the front of the valve is a brass indicator panel. At the top of the panel is engraved SHUT, while at the bottom of the panel is engraved ...REL32981.041
-
HMAS Brisbane : Engine Room : Gauge from Engine Board
Technology
Maker: Unknown Weksler Instruments
The gauge is circular, with a machined alloy body and a grey rim. The face is white and is protected by an acrylic Perspex disc. It is calibrated from 0-1000 and has a red line indicator at 350. Nomen...REL32981.006
-
HMAS Brisbane : Engine Room : Light and Warning Sign
Technology
Maker: Unknown
The fluorescent light has a rectangular pressed metal case. On the upper surface are six screws and two large bolts (fitted). On the lower surface there are two cover sections at the ends, and in the ...REL32981.004
-
HMAS Brisbane : Engine Room : Propeller Revolution Indicator Gauge
Technology
Maker: Unknown
The propeller revolution indicator gauge has a square cast alloy cover, with an inset circular acrylic disc in the middle. The cast alloy body of the unit is attached to the Engine Room gauge board. T...REL32981.024
-
HMAS Brisbane : Engine Room : Salinity Indicator
Technology
Maker: Marine Electric Corporation Unknown
The salinity indicator consists of a rectangular steel case. At the rear, four attachment brackets have been cut. A rectangular access panel was mounted on the bottom (missing). The cover is hinged on...REL32981.028
-
HMAS Brisbane : Engine Room : Status Board No.1 Engine room
Technology
Maker: Unknown
The status board is located in the HMAS Brisbane Engine Room. The board is made up of a rectangular piece of wood, covered with a rectangular piece of white plastic, which is glued to the front. On th...REL32981.001
-
HMAS Brisbane : Engine Room : Switch unit
Technology
Maker: Palmer Unknown
The brass switch consists of a pressed metal case with a single attachment bracket welded to the back and drilled for two bolt holes. There are two cable fittings in the side of the case. The face is ...REL32981.031
-
HMAS Brisbane : Engine Room : Tartar Missile Launch Magazine Plate
Technology
Maker: Unknown
The tarter missile launch plate is a rectangular alloy plate with printed instructions for procedures that should be followed in case of Harpoon Fuel Leakage. It also contains instructions for recomme...REL32981.008
-
HMAS Brisbane : Fencing and Cabling missile launch cap
Technology
Maker: Unknown
The fencing and cabling is made up of four 1420mm long and three 1115mm long grey metal poles. The poles are 50mm in diameter. Each pole is secured to a metal bracket at its base which is then bolted ...REL33076
-
HMAS Brisbane : Fire Extinguisher holder
Technology
Maker: Unknown
The fire extinguisher holder is rectangular at the back with angles sides and base. It is made of metal and painted red. It has a black belt with buckle connected to the left hand side, which is used ...REL32993
-
HMAS Brisbane : Flag Locker
Technology
Maker: Unknown
The flag locker consists of a rectangular alloy casing, made of riveted sheets attached to a welded alloy L channel frame. The top edge of the case is angled with the height of the unit rising toward ...REL33210
-
HMAS Brisbane : Flag Locker : Alphabetical flag 'Z for Zulu'
Technology
Maker: Unknown
Standard rectangular flag used on the HMAS Brisbane. The background (field) is divided into four equal triangles. Clockwise, the colours are yellow, blue, red and black. The flag represents the letter...REL33210.128
-
HMAS Brisbane : Foot switch
Technology
Maker: Unknown
Foot switch, made of metal, painted grey. The switchl is rectangular at the back and rounded at the front. The top section of the foot switchl is grooved for better grip. A power cable protrudes from ...REL32990
-
HMAS Brisbane : Frame
Technology
Maker: Unknown
This frame is intended to be used with the Gun Plot Room door, but was collected from elsewhere in the ship. The door frame consists of a heavy L channel which is welded to the wall section. On the ch...REL32980.100
-
HMAS Brisbane : Gun Cleaning Brush (section of)
Technology
Maker: Unknown
The gun cleaning brush consists of a heavy alloy rod with a 10cm wide band of radial bristles. The centre of the rod is pierced and is fitted at each end with a section of threaded metal rod, projecti...REL32986
-
HMAS Brisbane : Gun Plot Room : Air Duct inspection cover and adjacent tally plate and bracket.
Technology
Maker: Unknown
The air duct inspection cover is a disc shaped assembly, fabricated from sheet alloy, with stamped sections welded as required and a central steel attachment point. The associated bracket/latch is a s...REL32980.021
-
HMAS Brisbane : Gun Plot Room : Air Filter
Technology
Maker: Unknown
The air filter is rectangular sheet metal case. The lid is made of L shaped channel and wire mesh and is retained by four screws. On the rear of the case is a circular hole with four screw holes and a...REL32980.048
-
HMAS Brisbane : Gun Plot Room : Aluminium cover
Technology
Maker: Unknown
The cover is a rectangular alloy sheet with two folded edges, located on one long side and one short side. On the opposite long side the edge is pierced by three holes, a length of rope with taped end...REL32980.095
-
HMAS Brisbane : Gun Plot Room : Aluminium cover
Technology
Maker: Unknown
The cover is a rectangular alloy sheet with two folded edges located on one long side and one short side. On the opposite long side the edge is pierced by three holes, a length of rope with taped ends...REL32980.096
-
HMAS Brisbane : Gun Plot Room : Aluminium floor plate
Technology
Maker: Unknown
Rectangular alloy plate with a cut-out section on one corner. The panel has two irregular holes cut together with two drilled holes. This is believed to be a sample of floor panelling from the GPR. Th...REL32980.086
-
HMAS Brisbane : Gun Plot Room : Amplifier Mk 76 Mod 8,
Technology
Maker: Unknown
The Amplifier Mk 76 Mod 8 consists of 2 rectangular consoles placed side-by-side. This is console 1 of 2. The console consists of two cabinets, divided into top and bottom sections. On the top section...REL32980.006
-
HMAS Brisbane : Gun Plot Room : Amplifier Mk 76 Mod 8,
Technology
Maker: Unknown
The Amplifier Mk 76 Mod 8 consists of 2 rectangular consoles placed side-by-side. This is console 2 of 2. The console consists of two cabinets, divided into top and bottom sections. On the top section...REL32980.007
-
HMAS Brisbane : Gun Plot Room : Bookshelf
Technology
Maker: Unknown
The shelf is constructed as an open-topped rectangular metal box. On the inside rear wall is a U channel for fitting a shelf divider. On the front face the end walls have folded edges and are about 1/...REL32980.088
-
HMAS Brisbane : Gun Plot Room : Bookshelf
Technology
Maker: Unknown
The shelf is constructed as an open-topped rectangular metal box. On the inside rear wall is a U channel for fitting a shelf divider. On the front face the end walls have folded edges and are about 1/...REL32980.089
-
HMAS Brisbane : Gun Plot Room : Bookshelf
Technology
Maker: Unknown
The shelf is constructed as an open-topped rectangular metal box. On the inside rear wall is a U channel for fitting a shelf divider. On the front face the end walls have folded edges and are about 1/...REL32980.090
-
HMAS Brisbane : Gun Plot Room : Bookshelf
Technology
Maker: Unknown
The shelf is constructed as an open-topped rectangular metal box. On the inside rear wall is a U channel for fitting a shelf divider. On the front face the end walls have folded edges and are about 1/...REL32980.091
-
HMAS Brisbane : Gun Plot Room : Box of brackets
Technology
Maker: Unknown
A rectangular, red plastic box filled with small brackets and screws, which have been painted white. The box has masking tape over the top upon which is hand-written `Cease Fire Salvo Signal Board'.REL32980.062
-
HMAS Brisbane : Gun Plot Room : Bracket
Technology
Maker: Unknown
The bracket is attached to the wall of the GPR, adjacent to the hull of the ship (opposite door). It consists of two rectangular steel plates welded at the rear to a Z shaped U section channel frame. ...REL32980.102
-
HMAS Brisbane : Gun Plot Room : Cease Fire-CKT 2U
Technology
Maker: Unknown
The Cease Fire Circuit is a pressed brass case, circular in shape and has been painted dark blue. The top of the unit has a square brass panel attached. In the middle of the panel is a brass switch th...REL32980.066
-
HMAS Brisbane : Gun Plot Room : Chair
Technology
Maker: Unknown
The chair consists of a heavy tubular base terminating at the base in a square mounting bracket with four holes. Attached to the top of the base are two square metal plates incorporating a swivel mech...REL32980.081
-
HMAS Brisbane : Gun Plot Room : Chair
Technology
Maker: Unknown
The chair consists of a heavy tubular base terminating at the base in a square mounting bracket with four holes. Attached to the top of the base are two square metal plates incorporating a swivel mech...REL32980.082
-
HMAS Brisbane : Gun Plot Room : Cover
Technology
Maker: Unknown
The cover is rectangular, made from a folded sheet of alloy, painted grey. It consists of a top and two sides. Each side has four holes for bolting them to the correct piece of equipment. On the top o...REL32980.093
-
HMAS Brisbane : Gun Plot Room : Cover panel
Technology
Maker: Unknown
The cover panel is a large grey sheet of flat metal. One side of the panel has a slightly curved lip. There are several drill holes around the edges of the panel and several in the middle in no partic...REL32980.103
-
HMAS Brisbane : Gun Plot Room : Cover panel
Technology
Maker: Unknown
The cover panel is a large grey sheet of flat metal. One side of the panel has a slightly curved lip. There are several drill holes around the edges of the panel and several in the middle in various l...REL32980.087
-
HMAS Brisbane : Gun Plot Room : Electrical Box
Technology
Maker: Unknown
The electrical box consists of a pressed circular brass body, with circular front plate, both painted dark blue. The front plate has a centrally mounted female electrical socket with leashed cover. At...REL32980.068
-
HMAS Brisbane : Gun Plot Room : Electrical Box
Technology
Maker: Unknown
The electrical box has a pressed circular brass body with a circular front plate. The unit is partially painted dark blue. The front plate has a centrally mounted female electrical socket (cover missi...REL32980.070
-
HMAS Brisbane : Gun Plot Room : Electrical Box
Technology
Maker: Unknown
The electrical box has a rectangular metal case with rounded corners, with a pressed metal convex lid. The entire box has been painted white. Around the edges of the box are 10 bolts. There are two, s...REL32980.076
-
HMAS Brisbane : Gun Plot Room : Electrical Box
Technology
Maker: Unknown
The electrical box is attached directly to the wall of the gun plot room. The box is a rectangular grey box, with a removable lid with three cable access points. There are four air-vents ' 2 on the ri...REL32980.013
-
HMAS Brisbane : Gun Plot Room : Electrical box
Technology
Maker: Unknown
The electrical box has a pressed circular brass body with a circular front plate. The unit is partially painted dark blue. The front plate has a centrally mounted female electrical socket (cover missi...REL32994
-
HMAS Brisbane : Gun Plot Room : Electrical box
Technology
Maker: Unknown
The electrical box consists of a pressed circular brass body, with circular front plate, both painted dark blue. The front plate has a centrally mounted female electrical socket with leashed cover. At...REL32995